Hydraulic Mobile Tipper for 200 Litre Tote Bins
BTH/250/1060/M/G
Hydraulic Mobile Tipper Description
The hydraulic mobile tipper is designed to lift and tip a standard 200 Litre tote
bin at a height of 1060mm. The hydraulic mobile tipper is constructed from Grade
304 stainless steel and is a fully TIG welded construction throughout. This hydraulic
mobile tipper would be powered via a hydraulic power pack and would tip the containers
by the extension of a stainless steel hydraulic cylinder. The hydraulic mobile tipper
will operate on a 'dead mans handle' principle and is mobile on two fixed and two
swivel braked castors. The hydraulic cylinder will be fitted with a hydraulic fuse
to prevent the bin from falling in the unlikely event of a hose failure.
Safety Guard to PD 5304:2005 Safety of Machinery
The safety guard is constructed from 40 x 40 x 3mm stainless steel box section and
3mm wire, 40mm aperture stainless steel weld mesh to meet the requirements of PD
5304:2005 Safety of Machinery. It would enclose the hydraulic mobile tipper to a
height of 2200mm on two sides, 800mm at the front with a hinged door on the fourth
side. The guard door is electrically and mechanically interlocked preventing the
hydraulic mobile tipper from operating with the door open. In addition, the guard
door can only be opened when the lifting carriage is at the full down position.
Hydraulic Mobile Tipper Specification
|
DESCRIPTION
|
HYDRAULIC MOBILE TIPPER
|
|
MODEL No.
|
BTH/250/1060/M/G
|
|
CAPACITY
|
250Kgs
|
|
TIPPING HEIGHT
|
1060mm
|
|
TIPPING ANGLE
|
120 DEGREES
|
|
MACHINE HANDING
|
LEFT OR RIGHT HAND AVAILABLE
|
|
TIPPING CHUTE
|
OPTIONAL
|
|
CONTAINER DESCRIPTION
|
STANDARD 200 LITRE TOTE BIN
|
|
BASE ARRANGEMENT
|
MOBILE ON CASTORS
|
|
CONTROL CIRCUIT
|
24Vac (STANDARD)
|
|
ELECTRICAL RATING
|
IP65
|
|
POWERPACK |
415V, 50 Hz, 3 PHASE & NEUTRAL |
Hydraulic Mobile Tipper Application Story
This hydraulic mobile tipper was required to load ingredients into a dough mixing
vessel through a hatch at the end of the vessel. It was fully guarded to that the
lift and tip operation could be automated. The long narrow chute was required to
direct the ingredients into a small hatch aperture and it therefore tapers down
to only 300mm at the end.
|