Pneumatic Bin Lift for 1500 Litre Octobins
BTP/200/1000/B/G
Pneumatic Bin Lift Description
This pneumatic bin lift is designed to lift and tip an empty 1500 Litre stainless
steel Octobin at a height of 1000mm to allow the bin to be pressure washed. The
bin is tipped through an angle of 100 degrees towards the operator to allow the
interior and exterior to be washed. The pneumatic bin lift is constructed from Grade
304 stainless steel and is a fully TIG welded construction throughout. The bin is
lifted and tipped via a pair of pneumatic cylinders. The pneumatic bin lift will
operate on a 'dead mans handle' principle and is designed to be bolted to the floor.
Safety Guard to PD 5304:2005 Safety of Machinery
The safety guard is constructed from 40 x 40 x 3mm stainless steel box section and
3mm wire, 40mm aperture stainless steel weld mesh to meet the requirements of PD
5304:2005 Safety of Machinery. It would enclose the pneumatic bin lift to a height
of 2200mm on three sides, with an interlocked gate at the front through which the
bin is loaded. The guard door is pneumatically interlocked preventing the pneumatic
bin lift from operating with the door open. In addition, the guard door can only
be opened when the lifting carriage is at the full down position.
Pneumatic Bin Lift Specification
|
DESCRIPTION
|
PNEUMATIC BIN LIFT/WASHER
|
|
MODEL No.
|
BTP/200/1000/B/G
|
|
CAPACITY
|
200Kgs
|
|
TIPPING HEIGHT
|
1000mm
|
|
TIPPING ANGLE
|
100 DEGREES
|
|
MACHINE HANDING
|
LEFT OR RIGHT HAND AVAILABLE
|
|
CONTAINER DESCRIPTION
|
1500 LITRE STAINLESS STEEL OCTOBIN
|
|
BASE ARRANGEMENT
|
BOLTED TO THE FLOOR
|
|
CONTROL CIRCUIT
|
PNEUMATIC
|
|
LIMIT SWITCHES
|
PNEUMATIC
|
Pneumatic Bin Lift Application Story
This pneumatic bin lift was designed to lift and tip a large stainless steel Octobin
that had contained the ingredients for the manufacture of various cooking sauces
for cleaning. The pneumatic bin lift shown was mounted in a small room and to load
a bin the operator first opened the guard gate at the front. The bin could then
be loaded using a hand pallet truck and once the gate was closed, the bin could
be tipped towards the operator at an angle of 100 degrees. This allowed the inside
of the bin to be washed thoroughly and the wash water could flow out of the bin
freely.
|